Sony KD-32NX200U - Manual (Page 9)

Getting started
7
DIGIT AL DIGIT AL
PROG
DIGIT AL DIGIT AL
Finding your video channel 7
If you connected a VCR to your TV when following the ‘Connecting an aerial and a VCR
to the TV’ instructions, you now need to find your video channel.
1. Ensure the TV is in analogue mode. If not press the DIGITAL/ button on
the remote control.
2. Press the PROG+/- button on the remote control until the picture from the
pre-recorded tape appears on screen.
Notes:
If you wish to move your video channel to a different programme number, refer to the
‘Programme Sorting’ section of this manual.
If you connected your VCR using a scart lead, press the / button repeatedly on the
remote control until the picture from the pre-recorded tape appears on the TV screen.
Switching between digital and analogue programmes
6
1. Press the DIGITAL/ button on the remote control to switch between
digital and analogue mode.
Notes:
If the TV is in digital mode an information banner appears briefly on screen when you change
channels.
If the TV is in analogue mode the channel number appears in green lettering when you change
channels.
NX1-8.fm Page 7 Monday, September 16, 2002 12:24 PM