Samsung FTQ307NWGX User Manual
Page 60
60_ Troubleshooting
PROBLEM
POSSIBLE CAUSE
SOLUTION
The surface units
will not maintain
a rolling boil or
will not cook fast
enough.
Improper cookware is being used.
Use pans which are flat and match the
•
diameter of the surface unit selected.
In some areas, the power (voltage)
may be low.
Cover the pan with a lid until the desired
•
heat is obtained.
The surface units
will not turn on.
A fuse in your home may be blown
or the circuit breaker tripped.
Replace the fuse or reset the circuit
•
breaker.
The cooktop controls are set
improperly.
Check to see the correct control is set for
•
the surface unit you are using.
Pan does not heat
up
Pan not detected.
Check whether the pots or pans are
•
suitable for induction.
Refer to page 23 for proper pan selection.
•
Pan too small for proper pan
detection
and only works with low power.
Use larger pan or this pan on a smaller
•
cooking zone. Refer to page 23 for proper
pan selection.
Distance between surface unit and
glass ceramic is too large.
Check whether the surface unit is properly
•
positioned and touching the glass cooktop
surface.
Areas of
discoloration on the
cooktop
Food spillover was not cleaned.
Refer to the section on care and cleaning
•
of the glass cooktop on page 52.
The surface is hot and the model
features a light-colored cooktop.
This is normal. The surface may appear
•
discolored when it is hot. This is temporary
and will disappear as the glass cools.
The surface unit
frequently cycles on
and off.
This is normal.
The element will cycle on and off to
•
maintain the heat setting.
The oven will not
turn on.
The range is not completely
plugged into the electrical outlet.
Make sure the electrical plug is inserted
•
into a live, properly grounded outlet.
A fuse in your home may be blown
or the circuit breaker tripped.
Replace the fuse or reset the circuit
•
breaker.
The oven controls have been set
improperly.
See the chapter on operating the oven.
•
The oven is too hot.
Allow the oven to cool.
•
The appliance will
not turn on.
The appliance is not completely
plugged into the electrical outlet or
a fuse in your home may be blown
or the circuit breaker tripped.
Make sure the power cord is plugged into
•
a live, properly grounded outlet. Check the
fuse and circuit breakers.
Incomplete service wiring.
Call for service.
•
Power outage.
Check to see if the house lights will turn
•
on. If required, call your local electric
company for service.
The oven light will
not turn on.
The light bulb is loose or defective.
Tighten or replace the bulb.
•
The switch operating light is
broken.
Call for service.
•
FTQ307NWGX_XAC DG68-00229A.indb 60
2009-07-13 1:31:08