Smith Corona 200 - Manual (Page 5)

5
CONNECT POWER
Power cord is located in the compartment located at the rear of the typewriter. And
the power switch is located on the right side of typewriter near the rear.
1) Pull down the rear compartment door and connect the power cord to a proper
AC outlet.
2) Push the power switch to the “I” position.
When the typewriter is switched on, the green LED on the keyboard will light up.
The carrier will move to the extreme left of the typewriter then advance to the
left margin.
The unit is now ready for typing.
★
NOTE: The Socket-outlet shall be installed near the equipment and shall
be easily accessible.
Setting
When you open the printcover to change the RIBBON, DAISYWHEEL, CORREC-
TION TAPE or other reasons, and if you want to re-initialize your typewriter, press the
CODE + = (SETTING) key.
1) Open the printcover and change the RIBBON, DAISYWHEEL or CORRECTION
TAPE. Close the printcover.
2) Press the CODE + = (SETTING) key, the typewriter will then initialize itself. All
memories and carrier position will be maintained.
-4-