Smith Corona 200 - Manual (Page 6)

6
C H A N G I N G
Changing The Ribbon Cassette
1) Move the print carrier to the center of the platen using the SPACE or .
2) Hold the ribbon cassette on both sides and lift up the front portion (where the
ribbon is exposed) to remove the cassette.
3) To insert a new cassette, place the back end of the cassette on the cassette holder
on the carrier and gently press down on the front of the cassette unit it clicks into
place.
4) Turn the ribbon feed knob counter-clockwise again to take up any slack in the
ribbon.
5) Press the CODE + = (SETTING) key.
Changing The Print Wheel
1) Move the print carrier to the center of the platen using the SPACE ou .
2) You will see a lever on the right side of the carrier. Pull this lever toward you and
lift out the daisy wheel.
3) Place the daisy wheel into the slot with the characters facing the platen.
4) Push the lever back into position.
5) Press the
CODE + = (SETTING) key.
-5-