SIIG 101828 - Manual (Page 12)

Page 8
Port Settings
The parallel port drive will try to allocate the parallel port with FlashLink
automatically with the first run of the FlashLink software under the following
conditions:
Standard port address assignment
a) One parallel port configuration
LPT1 address: 0x378
b) More than one parallel port configuration
LPT1 address: 0x3BC
LPT2 address: 0x378
LPT3 address: 0x278
In all non-standard cases the user has to specify explicitly the LPT address of the
parallel port used with the FlashLink. This can be done using the Customize
Screen Æ Port Setup. (See next page for illustration.)