Siemens Gigaset S1 - Manual (Page 19)

19
Using several handsets
Gigaset S1 / englisch / A31008-S001-B002-2-6Z19 / start_guide_time.fm / 31.03.2003
When the room monitor is activated, incoming calls to the handset which is near the
baby are indicated without a ring tone, they are just shown on the display. The display
and the key pad are not illuminated.
When entering an external phone number, make sure that the line to which you want
the room monitor to be transferred is not blocked by an activated answering machine.
◆ If you redirect your room monitor to an external number, then you should tell that
number's owner.
◆ The room monitor's call to an external phone number stops after about 90 seconds,
to an internal number (handset) it stops after about 180 seconds (depending on the
base).
Activating the room monitor function and entering the 'call to' number for
the first time
Step 1: Open the input field: v; s
Add. Features ; Room Monitor .
Step 2: Activate room monitor: r (in the Room M.: line, select On);
Step 3: Enter the destination number: s (to the next line);
Edit ;
Enter internal number: INT s (select handset) ; or:
Enter external number: ~; (open menu); Save Entry ;
Step 4: Set the sensitivity: if necessary press s (to the next line); r;
Save ;
The room monitor function is now activated.
Once the room monitor is activated, switch directly to the room monitor setting with
v
(open menu).
Deactivating the room monitor
You can deactivate the room monitor remotely (depending on the base). Take the call
from the room monitor and press O R. The room monitor function will deactivate
around 90 seconds after the call ends. The room monitor will make no further calls. The
other room monitor functions on the handset (e.g. no ringer) will remain activated until
you press the display key Off on the handset that is in the baby's room.
W Always check the settings of the room monitor before you leave
home, e.g. sensitivity and phone line.
i
The room monitor function severely curtails the handset's operating time.
If necessary you should place the handset which is near the baby in the
charger to ensure that the battery does not run down.
The room monitor function can also be used in Walk and Talk mode.
i
To reactivate the room monitor function with the same telephone
number, you must turn on the activation again and save with Save .
OK OK
OK
à
OK