Siemens Gigaset S1 - Manual (Page 6)

6
Preparing to use your phone
Gigaset S1 / englisch / A31008-S001-B002-2-6Z19 / start_guide_time.fm / 31.03.2003
Preparing to use your phone
The pack contains:
one S 1 handset, one charger, one belt clip for the handset, two batteries, a power
supply unit with power cord, one set of operating instructions.
Preparing to use the handset
The display is protected by a plastic film. Remove the protective plastic film!
Inserting the batteries
◆ Insert the batteries ensuring correct polarity – see figure on left.
◆ Position the battery cover so that it is open by around 3 mm, then slide up until it
closes with a click,
◆ To open the battery cover, press on the chequered area and slide down.
Placing the handset into the base (registering) and charging the batteries
When you place the S 1 handset into the S 100/S 150, C 100/C 150 or C 200/C 250 base,
it will register to the base automatically. Proceed step by step as follows:
1. Place the handset in the base with the display up.
2. Wait till the handset has registered automatically to the base: This operation takes
around one minute. While registration is in progress the screen displays
Regstr.Procedure
and Base 1 flashes. When the handset has registered, the
internal number that is assigned to it appears in the display (e.g. 'INT 2').
3. Now leave the handset in the charger for the batteries to charge - the batteries are
supplied uncharged. Battery charging is indicated in the top right of the display by
the flashing battery icon =.
W
Use only the rechargeable batteries recommended by Siemens on
page 24! Never use conventional batteries (non-rechargeable) or other
battery types as this may cause significant damage to health and
property. For example, the jacket of the battery could be destroyed
(hazardous). The phone could also malfunction or be damaged.