Siemens Gigaset S1 - Manual (Page 20)

20
Using several handsets
Gigaset S1 / englisch / A31008-S001-B002-2-6Z19 / start_guide_time.fm / 31.03.2003
Setting the Walk and Talk mode
The Walk and Talk function allows two handsets (maximum range 300 metres) to call
each other no matter how far they are from the base.
Precondition:
◆ Both handsets have been registered to the same base (recommended for the room
monitor function) or
◆ Both handsets are registered to different bases and both are set to Best Base
(page 8) or
◆ One of the handsets is not registered to any base and the registered handset is set
to Best Base or
◆ Neither handset is registered to a base.
In Walk and Talk mode the handsets cannot be reached by incoming calls. The handset
operating times are greatly curtailed.
Activating/deactivating the Walk and Talk mode
v (open menu); s
Add. Features ; s
Walk and Talk .
To deactivate: Press the display key Off .
Press c (Talk key) or d (handsfree key) The call will go to all handsets that are in Walk
and Talk mode. Ring and advisory tones are set in exactly the same way as if your
handsets were in range of the base (page 21 and page 21).
The ringer (page 22) and keypad lock (page 8) can be activated/deactivated in the Walk
and Talk mode.
To open the menu, press the display key
© .
Using a handset in Walk and Talk mode as a room monitor
(open menu); s
Room Monitor ; s (to the next line); select r (On);
s (to the next line); select r (Low or High);
Save .
The room monitor will only call handsets that are in the Walk and Talk mode.
Press the display key Off on the room monitor handset to deactivate the room monitor.
The handset returns to the normal Walk and Talk mode.
i
The Walk and Talk mode is retained even when you switch your handset
off and back on.
W
Always check the settings of the room monitor before you leave
home, e.g. sensitivity and phone line. The distance between the
handsets should not now be changed (range).
OK OK
à
OK