Sennheiser EK3253 - Manual (Page 13)

15
Using the receiver
Switching the receiver on/off
̈
To switch the receiver on, turn the volume control
Ƹ
to the
right until it clicks. The red LED
ᕣ
lights up.
̈
To switch the receiver off, turn the volume control
Ƹ
to the
left until it clicks. The red LED
ᕣ
goes off.
Note:
y The receiver has a short switch-on delay.
y Remove the batteries or the accupack when the receiver
will not be used for extended periods of time.
Connecting the headphones
Attention! High volume!
Even short exposure to high volume levels can damage your
hearing! Set the volume for the connected headphones to
the minimum before putting the headphones on. Do not
listen at higher volume levels than with loudspeakers.
»
Ƹ