Samsung DIGIMAX i50 - Manual (Page 155)

《155》
FAQ
● If a PC (Windows 98) stops responding while the camera and PC are connected repeatedly
→ If a PC (Windows 98) is turned on for a long time and the camera is connected repeatedly,
the PC may not recognise the camera. In this case, re-start the PC.
● If a PC connected with the camera stops responding while Windows is starting.
→ In this case, disconnect the PC and the camera and Windows will start.
If the problem happens continuously, set the Legacy USB Support to disable and re-start
the PC. The Legacy USB Support is in the BIOS setup menu. (The BIOS setup menu
differs from the PC manufacturers and some BIOS menus don’t have Legacy USB
Support) If you can’t change the menu by yourself, contact to the PC manufacturer or
BIOS manufacturer.
● If the movie clip can’t be deleted, removable disk can’t be extracted or an error message
displays during the file transfer.
→ If you install only the Digimax Master, the problems mentioned above occasionally
happen.
- Close the Digimax Master program by clicking the Digimax Viewer icon on the Taskbar.
- Install all the application programs included in the software CD.
(You must install the Movie clip codec)