Connecting your monitor for analog, Connecting your monitor for digital – Sunbeam FP5900 User Manual
Page 7
5
DEUTSC
H
ENGLISH
FRAN
Ç
AIS
ES
P
A
Ñ
OL
IT
ALI
A
N
O
JAP
A
NESE
COMPL &
W
A
RR
Connecting your Monitor for Analog
Be sure to read the ‘Safety
Information’ at the front of
this User Guide before
carrying out this procedure.
1.
Turn off your PC and all attached devices.
2.
Connect the signal cable to the video port on the back of your computer.
This port might be directly attached to your computer (figure A), or it
might be part of a video adapter card (figure B). The video port on your
computer or video adapter card may be colored blue to match the blue
connector on your monitor’s video cable.
T he A C adapter and signal
cable are connected to your
m onitor. If you w ish to change
these or to fit a different stand, see
Further Help
on page 25.
3.
Connect the power cord to the power adapter first, then insert the plug
into a properly grounded electrical outlet.
Connecting your Monitor for Digital
1.
Turn off your PC and all attached devices.
2.
Remove rear covers a, b and c per instructions 2, 3 and 4 on page 26.
3.
Locate DVI cable. It is shipped in a separate plastic bag in the shipping
carton.
Connecting DVI Cable
DVI
Cable
T84H_setup0915_final.fm Page 5 Monday, September 25, 2000 7:40 PM