Sterling SDF 250 - Manual (Page 60)

SDF 250/400/500
Assembly instructions 8-1
8. Assembly instructions
These installation instructions are intended for persons with
skills in electrical and mechanical areas due to their training,
experience and received instructions.
Personnel using these installation instructions must be instructed
in the regulations for the prevention of accidents, the operating
conditions and safety regulations and their implementation.
Ensure in each case that the personnel are informed.
The installation instructions provided in the corresponding
operating instructions apply for all connected equipment.
Observe safety regulations with regard to lifting gear handling.
All installation work must be carried out with the equipment
disconnected from electrical power and compressed air supply.
L
For installation work taking place at heights of over approx. 6 feet
(1829mm), use only ladders or similar equipment and working
platforms intended for this purpose. At greater heights, the
proper equipment for protection against falling must be worn.
Use only suitable lifting gear which is in proper working order and
load suspension devices with sufficient carrying capacity. Do not
stand or work under suspended loads!
Use suitable workshop equipment.
F
Install the equipment such that all parts are easily accessible; this
facilitates maintenance and repair work.