Sony Ericsson NAS-C5E - Manual (Page 31)

31 GB
NAS-C5E GB 3-280-821-12(1)
Oper
ation
Using the timer
Using the Sleep timer
You can set the Sleep timer so that the unit enters
standby mode automatically after a certain period
of time (Sleep timer function).
1
Press SETTINGS.
The Settings menu appears.
2
Select [Sleep timer].
3
Select the time interval from
[15minutes], [30minutes], [0minutes],
or [0minutes].
The Sleep timer is set and appears on
the playback display. After the selected
time elapses, the volume turns down
gradually and the unit enters standby
mode automatically.

Tips

You can also set the Sleep timer using the SLEEP
button on the remote control. Each time you press
the button, the interval changes as follows.
[Off]  [15minutes]  [30minutes]  [60minutes]
 [90minutes]  [Off]...

While the Sleep timer is set, press the SLEEP
button on the remote control to check the
remaining time before the unit enters standby
mode. If you press the button again, the Sleep
timer is set again.
Note
If you perform the following operations before the
Sleep timer goes off, the Sleep timer resets.

Disconnect the AC power adaptor.

Turn off the unit (the unit enters the standby
mode).

Perform [Network setting] in the Settings menu.

Perform [Option] – [Factory default] in the
Settings menu.
Using On-timer
You can set the On-timer to start playing the
desired source at a specified timer (On-timer
function). You can set up to two On-timers. Make
sure to set the clock before setting the On-timer
(page 15).
1
Select a track or the Internet radio
station that you want to play with the
On-timer.
2
Press SETTINGS.
The Settings menu appears.
3
Select [On-timer].
4
Select [Timer1] or [Timer2].
5
Select [On].
The On-timer setting display appears.
6
Set [Start: ] (start time) and [End: ] (end
time).
Press / to change the time and press
ENTER to enter the setting.
Each time you press ENTER, the cursor
moves as follows.
“hour” (start time)  “minutes” (start
time)  “hour” (end time)  “minutes”
(end time).
Press and hold / to change the
parameter sequentially.
7
Set the day of the week.
Press / to select the day and press
ENTER.
Each time you press ENTER, the selected
day is checked or unchecked.
Confirm that the day you want to set the
On-timer is checked, select [OK], and
then press ENTER.
Continued
