Sony Ericsson NAS-C5E - Manual (Page 37)

3 GB
NAS-C5E 3-280-821-11(1)
Troubleshooting
Problem Causes/measures

“The internal temperature of the
device is too high.” appears, and
the unit enters standby mode.

The On/Standby indicator
flashes (no message appear on
the display while the unit is in
the standby mode).
 If you use this unit at high-volume levels for a long time, the
internal temperature of the unit may become too high. Turn off
the unit, wait for a while until it cools down, and then turn on
again.
“An error has occurred in the
internal system.” appears and the
unit enters standby mode.  The system’s automatic protection function has activated.
Disconnect the AC power adaptor, wait about 30 seconds, and
then reconnect it.
Connecting the unit to the network using AOSS
Problem Causes/measures
“No wireless station/access point
in AOSS mode found.” appears.  The AOSS button on the wireless station/the wireless LAN access
point has not been pressed. Do the AOSS setup again.
 Place the unit and the wireless station/the wireless LAN access
point close to each other and do the AOSS setup again.

“An error occurred while
transferring AOSS information.”
appears.

“An error occurred in security
information.” appears.

“An error occurred while
transferring security key.”
appears.
 There was an information exchange failure between the unit and
the wireless station/the wireless LAN access point. Wait a while,
and then do the AOSS setup again.
 Place the unit and the wireless station/the wireless LAN access
point close to each other and do the AOSS setup again.
“Another device is connected to
the access point. Try again later.”
appears.  The AOSS setup is being performed for another device. Wait a
while, and then do the AOSS setup again.
“Multiple wireless stations/access
points in AOSS mode found. Try
again later.” appears.  Multiple wireless stations/wireless LAN access points in AOSS
mode were detected. Wait a while, and then do the AOSS setup
again.