Shelby CS-500S - Manual (Page 10)

. .
. .
19 10
OPERATION
J. DISARMING WITHOUT A TRANSMITTER
Overriding the Alarm without a Password Pin Code: (Factory Default
Setting)
The Override function may be used if the remote transmitter is lost or
inoperative.
1. Enter the vehicle and turn the ignition switch to the “ON” position.
(The alarm will sound.)
2. Within 10 seconds push and release the valet/program switch. The
alarm will stop sounding and enter the disarm mode. You can now start
and operate the vehicle normally.
Override the Alarm with Password Pin Code: (See Alarm Feature IV-
2 Programming.)
Unlike the valet switch easily found and defeated, this security system allows
the consumer to program a password pin code. This feature will offer a
higher level of security protection
To Operate Password Pin Code:
1. Enter the vehicle and turn the ignition switch to the “ON” position.
(The alarm will sound.)
2. Within 5 seconds, enter your chosen first digit code by pressing and
releasing the valet/program switch.
3. Within 15 seconds of the last digit code enter (the 1st code), turn the
ignition switch “OFF” and then back to the “ON” position.
4. Within 15 seconds, enter your chosen second digit code by pressing
and releasing the valet/program switch.
5. Turn the ignition switch to the “OFF” position. [4] Chirps from the siren
or horn and [3] flashes from the parking lights will indicate the system
was disarmed.
Example: To Override the System with the Password Code 83, you
would;
1. Enter the vehicle and turn the ignition switch to the “ON” position.
(The alarm will sound.)
2. Within 5 seconds, press and release the valet/program switch 8
times.
LCD REMOTE CONTROL TRANSCEIVER
C. PROGRAMMING THE LCD REMOTE TRANSMITTER:
Transmitter Description Operation
Button
F (1 sec.) LCD Screen Lamp Turns Press and hold for 1 sec.
On for 5 Sec. 1 melody sound will confirm.
F (3 sec.) Timer Programming Mode Press and hold for 3 sec.
2-melody sounds will confirm.
F (5 sec.) Power Save Mode Press and hold for 5 sec.
1 melody sound will confirm.
F- F- F Clear the Flash Icon and Press within 3 sec.
Melody Sound on the LCD
Screen Transmitter
F- (2-sec.) Button Lock ( ) enable / Press within 3 sec.
disable
F- (2 sec.) Melody / Vibration ( ) Press within 3 sec.
F- (2-sec.) Program Count Down Press within 3 sec. cycling
(Parking) Timer (10-Minute/ leave the buttons starting
20M/30 M/1Hour/1.5H/2.0H) count down then
flashes
F - (2 sec.) Enable/disable Bi sound (Bi)
while pressing button