Shelby CS-500S - Manual (Page 12)

. .
. .
17 12
OPERATION
L. CAR FINDER:
With the unit Armed, press the button to activate the Car
finder function. The siren will chirp 6 times and the
parking lights will flash 12 times to locate your vehicle.
M. PANIC FUNCTION:
The transmitter can be used as a remote panic button to
manually trigger the alarm in case of emergency.
To enter “Panic Mode”:
1. Press and hold the button for 3 seconds. The alarm will
immediately sound.
2. During “Panic Mode”, the normal function of this transmitter button will
be suspended. The transmitters and buttons can be used to lock
and unlock the doors, however once the button is pressed, the vehicle’s
starter disable device, (if installed) will be disabled allowing the vehicle
to start.
3. To stop the alarm, press and hold the button on the transmitter again
for 3 seconds. Also, if any transmitter button other than or or is
pressed and released, the panic mode will be turned off immediately.
4. If the button is not pressed, the alarm wil automatically stop after 30
seconds.
N. TRIGGER THE ALARM SYSTEM
When Armed, your vehicle is protected as follows:
1. Light impact will trigger the warn-away signal.
2. Heavy impacts, doors opening, hood opening, trunk opening or turning
the ignition “ON” will trigger the programmed sequence. The starter
disable relay (if installed) prevents the vehicle’s starter from cranking.
The siren, horn, parking lights, and dome light will turn on to alert
an intrusion for 30 seconds. The system will then stop and automatic
reset or re-arm. If one of the sensors or detectors is active, the alarm
system will sound a maximum of 6 times in 30 seconds cycles.
LCD REMOTE CONTROL TRANSCEIVER
Note:**** If the system is interfered with by stronger
radio frequencies, sources of high voltage, electric
power or obstacles like tall buildings, the transmission
range may get shorter as this system uses a low
powered output frequency.
A. BATTERY REPLACEMENT:
A 1.5V type AAA Alkaline battery powers the Remote Transmitter.
When the power of the battery weakens, a icon will be displayed on the
LCD screen. When the old battery is replaced with a new one, a beeping
sound will indicate the power is up and the clock on the LCD screen will
return to AM12:00 after displaying all the icons. Reset the correct time by
pressing F for 3 seconds before using the remote control (See Timer
Setting.) Press the button twice when the battery compartment
is empty, then insert the new battery.
Note: Press the button [2] times with
the battery removed from the remote,
then insert the new battery.
B. THE REMOTE LCD ICON DESCRIPTION CHART :
Door Lock Door Unlock
Your vehicles doors are locked. Your vehicles doors are
unlocked and the system is
disarmed.
Armed Mode Valet Mode
Your vehicle is in the All the function shall be
armed mode. temporarily on hold.