Samsung SP-H700 - Manual (Page 14)

1. Refer to the manual of the device the projector is connected to. The number and
position of ports may differ depending on type of devices.
2. Do not connect power until all the connections are completed. If you try to connect
power while connecting cables, it may result in damage to the projector.
3. Check the type of ports the projector is connected to.
Check the following Before Connecting
CONNECTING TO VIDEO EQUIPMENT
Connecting to VCR/Camcorder/Cable Box
Before Connections
Check the followings before connecting the projector to other devices.
Connections and Source Setup
Before Connections
Connections and Source Setup
Connecting to Video Equipment
26 27
Connect COMPOSITE (yellow) input port of the projector to the VIDEO (yellow)
OUT port of video equipment using the video cable.
■ If the video equipment has S-VIDEO OUT port, connect it to S-VIDEO input port of the projector.
Turn on the projector and press the
COMPOSITE button to select Composite.
Connect the projector and the video
equipment via S-Video cable and press the
S-VIDEO button to select S-Video.
■ When Composite Mode is not available, check the
video cables are in place.
1
Viewing the picture
NOTE
■ Check that the projector and the video
equipment are turned off before connecting
cables.
■ This projector does not support sound.
(Separate audio system is needed for sound.)
Rear side of Projector
VCR
S-Video Cable Video (Composite) Cable
Cable Box
Camcorder
Composite COMPOSITE
1
S-VIDEO
2
or
Rear Connection
Refer to "Rear Side and Cables" on page 14 for cables used for connection.
2