Sony BKP-7933 - Manual (Page 16)

1-10 (E)
BKP-7933
1-7. Setting Up
n
The description in this section assumes that the BKPF-R70 is used as the primary station.
1-7-1. Outline
Calling the Menu Display of the Secondary Station
First, call the menu display of the secondary station that is connected to the S-BUS of the primary station.
Procedure
1. Call the SETUP MENU of the primary station by
pressing [Ctrl]- [X].
Then, select the menu item “R:CALL SECONDARY
STATION” and press [ENTER].
1-7. Setting Up
SONY ROUTING SYSTEM SETUP MENU BKPF-R70 V1.02T STATION NUMBER 1
MODIFICATION COMMAND
A: DISPLAY CONTROL AREA B: SET SOURCE/DEST TYPE
C: SET DESTINATION NAME D: SET SOURCE NAME
E: SET LEVEL TABLE F: SET ACTIVE UNIT NUMBER
G: UPDATE BACKUP CONTROLLER H: SET GLOBAL PHANTOM
J: NAME STYLE(Type + Num) K: RESET TO DEFAULT TABLE
L: SET PHYSICAL ASSIGNMENT M: SET INHIBIT TABLE
N: SET DESCRIPTION NAME GROUP O: SET TIE LINES
P: CHANGE PASSWORD Q: CHANGE CROSSPOINT
R: CALL SECONDARY STATION
MAINTENANCE COMMAND
------------------ T: SET CLOCK
U: SELECT CONTROL MODE V: SELECT WARNING DISPLAY (ON)
W: SYSTEM STATUS LOG X: DISPLAY S-BUS COMMUNICATION
Y: DISPLAY TABLE DATA Z: SET UNIT DETECTABLE
Ctrl_X:QUIT SETUP MENU
SONY ROUTING SYSTEM SETUP MENU BKP-7933 V1.00 STATION NUMBER 2
MODIFICATION COMMAND
A: SET UNIT LOCATION(CAM-CCU) B: SET UNIT LOCATION(CCU-RCP)
C: SET UNIT LOCATION(MSU)
K: RESET TO DEFAULT TABLE
MAINTENANCE COMMAND
Z: BKP-7933 CONFIGURATION
Ctrl-D RETURN
2. When the message “CALL STATION NUMBER?”
appears, input the S-BUS ID number of the BKP-7933
using the numeric keys and press [ENTER]. The
display changes to the called BKP-7933 menu display.
m
. If the specified BKP-7933 does not exist on the S-
BUS data link, an error is displayed.
Display: “Station does not exist”
. If the specified BKP-7933 is outside the communi-
cation target, an error is displayed.
Check using the menu item “F:SET ACTIVE UNIT
NUMBER”.
Display: “Disable Station”