Sanyo TLS-224P - Manual (Page 22)

NORMAL PLAYBACK
Normal Playback
1
Turn on the power to the VCR and TV monitor.
2
Load the video cassette tape.
3
Press the REC/PLAY SPEED button to select the
playback speed.
° The selected playback speed is displayed on
the digital display.
NOTE:
•
A slow motion effect or accelerated playback
effect can be achieved by using a slower or faster
playback speed than the speed used for
recording.
4
Press the PLAY button.
° Playback starts.
° If necessary, adjust the tracking to eliminate
the noise from the picture.
5
To stop playback, press the STOP button.
° To advance or rewind the tape, press the FF
or REW button.
NOTES:
•
A tape recorded on a time lapse VCR produced by
another manufacturer can not be played back on this
unit.
•
A tape recorded on this VCR cannot be played back
on a time lapse VCR produced by another
manufacturer.
Tracking Control
If there is noise in the image during playback,
1
While looking at the playback picture, press and
hold the TRACKING/V. STILL+ button to minimize
the noise.
2
If it cannot be minimized, press the TRACKING/V.
STILL– button.
Vertical Lock Control
During still image mode,
1
Press and hold the TRACKING/V. STILL+ button to
reduce the vertical rolling of the image.
2
If it cannot be corrected, press the TRACKING/V.
STILL– button.
Audio Playback
•
The playback speed has to be the same as the
recording speed, for normal playback of the audio.
•
For a tape recorded in 12-hour and 24-hour recording
modes, to playback the audio, press the AUDIO
ON/MENU button after pressing the PLAY button. “
? ”
will be displayed to the left of the playback speed on
the digital display.
NOTE:
•
Noise will appear in the image when audio playback
is used in 12- or 24-hour modes.
GB
NE4QG/EX (TLS-224P GB) Mon. May, 11/1998
English 21