Sony DAV-LF1H - Manual (Page 30)

30 GB
G
e
tting
Star
te
d –
B
A
SIC –
8
Press .
The Setup Display for selecting the output
method for video signals from the EURO
AV T OUTPUT (TO TV) jack appears.
9
Press X / x to select the output method
for video signals.
• [VIDEO]: outputs video signals.
• [RGB]: outputs RGB signals.
Note
• If your TV does not accept RGB signals, no
picture appears on the TV screen even if you
select [RGB]. Refer to the instructions supplied
with your TV.
10
Press .
The [AUTO CALIBRATION] display
appears.
11
Connect the calibration mic to the
ECM-AC1 jack on the rear of the
subwoofer and set up the calibration
mic at the ear level using a tripod, etc.
(not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
Note
• Place the calibration mic so that the “FRONT”
side of it is pointed toward the front speakers.
12
Press X / x to select [YES], then press
.
[AUTO CALIBRATION] starts. Be quiet
during the measurement.
Note
• Loud test sound is output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbor.
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 1 minute), as it may interfere with
measurement.
• If the sound of the surround speakers is not
output, adjust the wireless system. See
“Adjusting the IR transmitter and IR receiver of
the surround speaker (L)” (page 28).
SCREEN SETUP
TV TYPE:
HDMI RESOLUTION:
YC
B
C
R
/RGB (HDMI):
16:9
AUTO
YC
B
C
R
SCREEN SAVER: ON
JACKET PICTURE BACKGROUND:
FULL
4:3 OUTPUT: VIDEO
VIDEO
RGB
LINE:
Connect calibration mic. Start
measurement?
YES
AUTO CALIBRATION
NO
VIDEO 1 VIDEO 2
VIDEO 2
TV VIDEO 1
AUDIO IN AUDIO IN DIGITAL IN
OPTOCAL
L
R
DIGITAL IN
DIGITAL
IN
COAXIAL
COAXIAL
ECM-AC1
Calibration mic
Rear of the subwoofer