Sony DAV-LF1H - Manual (Page 40)

40 GB
Tip
• When you connect both the analog and digital cord for the VIDEO 1 or 2 connection, the digital signals have
priority over the analog signals.
To connect the VIDEO OUT jacks of other component to the VIDEO 1 or
2 (VIDEO IN) jacks of this system
Connect the VCR or other components to the VIDEO 1 or 2 (VIDEO IN) jacks using the video cord.
Note
• The video signal that is input from the VIDEO IN jack is not output from the S VIDEO OUT jack.
To connect the AUDIO OUT jacks of other component to the VIDEO 1 or
2 (AUDIO IN) jacks of this system
Connect the VCR or other components to the VIDEO 1 or 2 (AUDIO IN) jacks using the audio cord
(not supplied). When connecting a cord, be sure to match the color-coded sleeves to the appropriate
jacks on the components.
If you connect a digital satellite receiver with an DIGITAL OUT
(COAXIAL) jack
The digital satellite receiver can be connected to the VIDEO 1 or 2 (DIGITAL IN COAXIAL) jack
instead of the VIDEO 1 or 2 (AUDIO IN) jacks of the system.
The system can accept both the digital and analog signals. Digital signals have priority over analog
signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.
If you connect a digital satellite receiver without an DIGITAL OUT jack
Connect the digital satellite receiver to the VIDEO 1 or 2 jacks only of the system.
Note
• Be sure to make connections securely to avoid hum and noise.
• When connecting the jack, insert the plug into the jack as far as it will go.
Yellow (Video)
White (L/audio)
Red (R/audio)
Example
Correct
Incorrect