Samsung BN68-01780A-00 - Manual (Page 30)

English - 
Network Connection
LAN Connection for a DhCP Environment
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described
below. Since an IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is
selected, you do not have to enter them manually.
tV Rear Panel
the Modem Port
on the Wall
Modem Cable 
External Modem
(ADSL/VDSL/Cable tV)
LAN
Cable 1
1. Connect the [LAN] port on the rear panel of the TV and the external modem with a LAN Cable.
2. Connect the LAN port on the wall and the external modem with a Modem Cable.
tV Rear Panel
the Modem
Port on the Wall
External Modem
(ADSL/VDSL/
Cable tV)
IP Sharer
LAN Cable
Modem Cable
You can connect the LAN via a Sharer (Router).
LAN Cable
The terminals (the position of the port and the type) of the external device may differ depending on the
manufacturer.
If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on
again after at least 10 seconds and then try again.
For the connections between the external modem and the Sharer (Router), refer to the owner’s
manual of the corresponding product.
You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have
to use an automatic-connection-type ADSL modem.
➣
➣
➣
➣
BN68-01780A.indb 28 2008-08-28 �� 6:38:22