Shindaiwa SV212 - Manual (Page 15)

15
ENGLISH
s
hredder
V
aC operaTIon
WARNING
Flying debris hazard. Never operate unit as a vacuum unless
discharge elbow is installed and debris bag is securely cinched to
elbow. Failure to follow instructions can result in serious injuries.
1. Adjust debris bag strap to support bag on operator’s shoulder.
Bag must not be folded at intake area, or intake will clog. Further
adjustment may be necessary as the debris bag fills and becomes
heavier.
2. Grip throttle handle with left hand, and support handle with right
hand. Keep unit to your right side so hot exhaust will be directed
away from you.
3. Operate unit with beveled end of tube facing downward. Keep
tube opening close to material being vacuumed for best results.
NOTE
Vacuum action works best at higher engine speeds. Avoid using
vacuum in areas where rocks or other large, hard debris may be
vacuumed into unit. Clear these areas with blower first, blowing
light debris into a pile. Use attachment to vacuum pile.
s
hredder
V
aC TroubleshooTInG
Problem Cause Remedy
Unit runs, but doesn’t vacuum or
has poor suction
Elbow or debris bag clogged Check elbow and debris bag, and clear as
needed. Make sure bag is not folded over
at intake during use.
Obstructions in vacuum tube Check vacuum tube, and remove
obstructions. Avoid wet leaves.
Unit stopped suddenly during vacu-
uming, and now starter won’t work
Object stuck in fan housing area
Unit jams repeatedly during use Material being vacuumed too big or
too hard for blades to shred Use vacuum for leaves and small
twigs, maximum 1/4” diameter x 3”
long.
Vacuum tube difficult to install or
remove from unit
Tube/housing fit tight.
Remove vacuum tube and check fan
area. Remove object.
4. Empty bag when debris level reaches intake opening. To empty bag, move stop switch to “Stop” position, and wait
for blower to stop running. Loosen Velcro strap at elbow and slide bag off elbow. Open other end of bag, and empty
contents. Close bag, and reattach to blower. Secure bag with Velcro strap.
Apply small amount of soapy water to
end of tube to ease assembly or re-
moval. Turns tube 1/4 turn to loosen for
removal.