Samsung IPOLIS SNP-3300 - Manual (Page 96)

30X PTZ Network Camera SNP-3300
92
5.6. Initialization Setting
Initialization Menu
① Power On Reset
Camera is initialized into the original status of power input.
② Factory Default Settings
Camera is initialized into the factory default settings. Data including
Preset is deleted. This function is used for initialization all settings.
③ Camera Default Settings
If only the camera module is replaced due to camera module failure,
the new camera module can be set up with the settings of the old
camera module.
➍
Auto Refresh
The electric circuit and the status of the equipment parts within the
camera are optimized regularly. (The cycle can be set up.) If camera
faces toward a certain source of light or if the settings cannot be
kept because of the long time rotation filming of a certain area, the
Auto Refresh function is used to maintain and re-set the existing
camera settings. Default setting is OFF.
ƒ OFF, 1-7 Days : This function is disabled in the OFF mode. 1-7
Days enables the Auto Refresh operation in the interval of the
selected days. Auto Refresh takes less than 10 seconds. The
message “Auto Refresh” disappears after finishing the operation.