Samsung SilverCare Washer - Manual (Page 8)

A-4 SAMSUNG Clothes Washer Owner’s Instructions
IMPORTANT TO INSTALLER
Please read the following instructions carefully before installing your Washer.
These instructions should be retained for future reference
STEP 1
Removing the Shipping Bolts
Before using your Washer, you must remove the four shipping
bolts from the back of the unit.
1. Loosen all bolts with the supplied spanner.
2. Slide the bolt and spacer up and remove the bolt with
spacer through the hole in the rear wall of your Washer.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
STEP 2
Selecting a Location
Before you install your Washer, make sure the location:
• Has a hard, level surface
• Is away from direct sunlight
• Has adequate ventilation
• Will not be freezing (below 32°F or 0°C)
• Is away from heat sources such as coal or gas
• Has enough space so that your Washer need not stand on its power cord
• Doesn’t have any carpeting that will obstruct ventilation openings.
STEP 3
Installing your Washer
1. Place the drain hose in the drain facility. Be sure an airtight
connection is NOT made between the drain hose and the
standpipe.
Standpipe must be at least 18 in or 46 cm high.
NOTE: Caution must always be exercised to avoid collapsing
or damaging the drain hose. For best results, the drain
hose should not be restricted in any way – by elbows,
couplings, or excessive lengths. For situations where the
drain hose cannot be conveniently elevated to at least 18
in or 46 cm, the drain hose must be supported.
2. Check the inlet hose to ensure a washer is inside each fill hose.
Thread the inlet hoses to the HOT and COLD faucet connections.
On the other end of the hose, check for one rubber washer per
hose and install each fill hose to the water valve. Make sure the
hose with the red line is attached to the HOT faucet. Tighten by
hand until snug, then two-thirds of a turn with pliers.
NOTE: For correct water use, connect both HOT and COLD
water valves. If one is not connected, “nF” (no fill) error
can occur.
Installing Your Washer
LAUNDRY TUB
STAND PIPE
HOSE
RETAINER
TIE
STRAP 96” MAX.
18” MIN.
96” MAX.
18” MIN.