Smeg 129530 - Manual (Page 7)

129530
The distance between the dryer and the moist air outlet
(vent shaft, window) should not exceed 2 meters,
otherwise water can accumulate in the tube.
B - Condenser dryer
• Laundry moisture is eliminated through the water condenser
and collected in the condenser tank. You can avoid possible
interruption of drying procedure due to full water condenser if
clothes have been dried at reduced number of spin revolutions
or when drying 6/7 kg of clothes. It is recommended to direct
the condense discharge hose directly to the drain. Before
installing remove the hose from the back side of the appliance
(left under the cover).
• Display reads CONTAINER FULL and a beep is heard when
the water receptacle is full and should be emptied, preferably
after each drying cycle.
• Use the power cord to connect the dryer to the power supply
via wall socket.
• Rated voltage and other characteristics are indicated on the
name plate, located under the door frame of the appliance.
The wall socket should always be within reach. It has to
be earthed according to the standing regulations.
If the supply cable is damaged it should only be
replaced by a qualifi ed technician.
Power connection Power connection
7