Sharp DX-C401 - Manual (Page 96)

94
SELECTING A SPECIAL MODE
The procedure for selecting a special mode for fax is explained below.
The settings that must be selected vary for each special mode, however, the
general procedure is the same. The procedure for erasing shadows at the
edges of the image when sending a fax is explained below as an example.
1 Place the originals.
When using the document glass,
place the original with the side to be
scanned face down.
2 Select settings in the touch
panel.
(1) Touch the [Special Modes]
key.
(2) Touch the [Erase] key.
The erase settings will be
configured to erase a width of 3/4"
around the edges of the original.
(3) Set the erasure width to
3/4" with the keys.
The erase area is set to "Edge
Erase" by default.
A particular side can be erased by
touching the [Side Erase] key and
selecting settings for that side.
(4) Touch the [OK] key.
The side to be scanned must be face up!
Auto
Auto
USB Mem. Scan Fax Scan
Standard
Auto Reception
Fax Memory:100%
Internet Fax PC Scan
Scan: Send:
File
Quick File
Address Review
Direct TX
Sub Address
Address Book
Special Modes
Resolution
Exposure
Original
1
2
Fax/Special Modes
Card Shot
Slow Scan
Mode
Business
Card Scan
OK
Quick File
Erase
File
Job
Build
Program Timer
Fax/Special Modes
Erase
Edge
Erase Edge
Cancel OK
OK
3/4
(0~1)
inch
Side Erase
8½x11
Transaction
Report
Own Name
Select
(1)
(2)
(4)
(3)
mxc401_us_qck.book 94 ページ ２００８年１０月１６日 木曜日 午前１０時５１分