Sony ShowView SLV-SE510B - Manual (Page 10)

10 Setting up the remote commander
Master Page : Left
filename[010get.fm] model name1[SLV-SE510B] [3-065-671-E1 (1) GB]
Step 2 : Setting up the remote commander
Inserting the batteries
Insert two R6 (size AA)
batteries by matching the + and
– on the batteries to the
diagram inside the battery
compartment.
Insert the negative (–) end first,
then push in and down until the
positive (+) end clicks into
position.
Using the remote
commander
You can use this remote
commander to operate this
VCR and a Sony TV. Buttons
on the remote commander
marked with a dot (
• ) can be
used to operate your Sony TV.
If the TV does not have the
symbol near the remote sensor,
this remote commander will
not operate the TV.
To operate Set [TV] / [MAGN] to
the VCR [MAGN] and point at the remote sensor at the VCR
a Sony TV [TV] and point at the remote sensor at the TV
1 2 3
4 5 6
7 8 9
0
Remote sensor
[TV] /
[MAGN]