Sony ShowView SLV-SE510B - Manual (Page 18)

18 Tuning your TV to the VCR
Master Page : Left
filename[010get.fm] model name1[SLV-SE510B] [3-065-671-E1 (1) GB]
To check to see if the TV tuning is correct
Set the TV to the video channel and press CHAINE +/– on the VCR. If the
TV screen changes to a different programme each time you press
CHAINE +/–, the TV tuning is correct.
To obtain a clear picture from the VCR
If the screen does not appear clearly in step 6 above, go to step 7 to finish this
procedure once. Then start again from step 2. After pressing REGL
CANAL in step 2, press CHAINE +/– while the RF channel is displayed, so
that another RF channel appears. Then tune the TV to the new RF channel
so that a clear picture appears.
5 Press CHAINE +/– (repeatedly) to select the appropriate TV system
for your area.
Select “L” for the L TV system (SECAM), or “G” for the B/G TV
system (PAL).
6 Tune the TV to the same channel
shown in the VCR display window so
that the picture on the right appears
clearly on the TV screen.
Refer to your TV manual for TV
tuning instructions.
If you select the wrong TV system in
step 5, the picture on the right may
not appear. Select the appropriate TV system and tune the TV
again.
If the picture does not appear clearly, see “To obtain a clear picture
from the VCR” below.
7 Press REGL CANAL.
You have now tuned your TV to the VCR. Whenever you want to
play a tape, set the TV to the video channel.
CHAINE
MAGNETOSCOPE SONY
REGLAGE AUTO
REGL CANAL