Skylink TOTAL PROTECTION ALARM SYSTEM SC-10 - Manual (Page 7)

– 7 – – 14 –
INSTALLATION
Installation is done using the screws included. For your convenience, we
have also included wall anchors and a template to aid in the installation of
the Audio Alarm and the Door/Window Sensors.
How to use the template to help in the installation:
1. Tape the template to the wall where you would like the component to be
2. Screw part way into the surface where the holes are marked on the template
3. Unscrew the screws and remove the template
4. Screw the component in place where you started the screws
We recommend that you install all components first with the double sided
tape included and once you are satisfied with the positioning, reinstall using
the screws.
INSTALLING THE AUDIO ALARM
The Audio Alarm is water resistance so it can be installed indoors or outdoors
within access to an electrical outlet. Be careful that the AC adapter wire
doesn't guide rain water to the DC JACK located at the bottom of the
Audio Alarm.
There are two ways to attach the Audio Alarm to the wall:
Hanging it on two stationary screws
1. Using the template provided, insert the two
screws into the wall.
2. Align the two top keyholes on the triangular
tabs located at the back of the Audio Alarm
with the screws on the wall.
3. Gently push the Audio Alarm on to these
two screws.
4. Open the small door on the bottom of the
Audio Alarm.
5. Insert the AC adapter and the antenna in
the appropriate holes.
6. Close the small door so that the AC adapter
and the antenna are running through the
appropriate spaces in the door.
DELETE SENSORS AND TRANSMITTERS
You can not delete one sensor/transmitter from the Audio Alarm at a time.
You must clear all the sensors and transmitters that are currnetly com-
municating with the Audio Alarm, then re-program the ones you want to keep.
Delete All Sensors and Transmitters
1. Turn the Audio Alarm off
by sliding the switch on the
bottom of the Audio Alarm
so that the “ON” light is not
lit.
2. Press and hold the learn
button found on the bottom
of the Audio Alarm.
3. While holding the button,
turn on the Audio Alarm by
sliding the switch on the
bottom.
4. You will hear a long beep
followed by a series of
short beeps. When you
hear the short beeps, re-
lease the learn button.
You have now cleared all sensors and transmitters from communicating with
the Audio Alarm.