Skylink TOTAL PROTECTION ALARM SYSTEM SC-10 - Manual (Page 9)

– 9 – – 12 –
INSTALLATION ACTIVATE AND DEACTIVATE THE SYSTEM
1. Position the transmitter be-
side the door/window frame on
the wall using either two sided
tape or screws. If you are using
screws, first pry off the back plate
with a small screwdriver and
screw the back plate into posi-
tion using the template. Then click
the transmitter on to the back
plate now mounted on the wall.
2. Position the magnetic switch connected to
the transmitter on the door/window frame.
3. Position the magnet on the door beside the
magnetic switch. They should be no more
than 1 cm (3/8 inch) apart. When the door/
window is closed, the magnets are in contact.
When the door/window is opened, contact is
broken and the transmitter sends a signal to
the Control Panel to activate the chime or
alarm.
Now that the system is installed and the sensors are communicating with
the Audio Alarm, it is time to learn how to arm and disarm the Audio Alarm.
The only way to arm and disarm the Audio Alarm is via the Keychain Trans-
mitter and Keypad Control (option).
When the Audio Alarm is ON, the four buttons on the transmitter do the
following:
Panic Button - instantly activates the alarm, whether the Audio Alarm is in
arm mode or not. Will always activate the alarm when the
“ON” light is lit on the Audio Alarm.
Button #1 - this button will arm the Audio Alarm so that the Audio Alarm
will communicate with the sensors and transmitters.
Button #2 - when the system is on but not armed and a remote sensor is
activated, the Audio Alarm will emit one chime, (beep). Button #2
allows you to activate or deactivate the chime sound. For example,
if people are using the frontdoor constantly, you may choose to
turn off the chime sound.
Button #3 -when the siren is sounding, this button will turn off the siren and
disarm the Audio Alarm.
- when the siren is not sounding but the system is armed, this
button will disarm the Audio Alarm.
KEYCHAIN TRANSMITTER 4B-434
Turns off the siren and/
or disarms the system #3
Arms the system #1
Activate/deactivate the
chime sound made
when a sensor is
#2 activated and the Audio
Alarm is not armed
Panic button