Skylink TOTAL PROTECTION ALARM SYSTEM SC-10 - Manual (Page 8)

– 8 – – 13 –
INSTALLATION
3. Position the Audio Alarm on the wall and
insert the two screws in the two keyholes.
Do not insert the screws all the way into
the wall, leave some room on the screw
to hang the Audio Alarm. We can also use
the template if needed.
4. Open the small door on the bottom of the
Audio Alarm.
5. Insert the AC adapter and the antenna in the
appropriate holes.
6. Close the small door so that the AC adapter
and the antenna are running through the
appropriate spaces in the door.
TO THE AUDIO ALARM
PROGRAM SENSORS AND TRANSMITTERS
The two Door/Window Sensors have been preprogrammed as well as the key-
chain transmitter at the factory to communicate with the Audio Alarm. If after
testing, there is no communication or you have purchased additional Door/
Window Sensors or Motion Sensors, (option), follow the instructions below:
Note: As many as 15 sensors and keychain transmitters can be programmed
to communicate with the Audio Alarm.
Program Door/Window Sensors & Keychain Transmitter
1. With only the “ON” light lit on the Audio Alarm, press and hold the learn
button located on the bottom of the Audio Alarm.
2. While pressing down on the button,
For Door/Window Sensor - press the button on top of the transmitter
of the Door/Window Sensor.
For Keychain Transmitter - press any of the four buttons on the Key-
chain Transmitter and hold for 2 seconds.
3. If a connection has been made, the Audio Alarm will stop beeping and
make a continuous tone until the "learn" button on the Audio Alarm is
released.
4. Now test the sensor by opening the door or window. If the Audio Alarm
beeps, they are communicating.
Note: If you are alone while programming the sensors, take the Audio Alarm
off the wall and bring it to the sensors so all the components are in one place.
Screwing the unit to the wall
1. Unscrew the two triangular hanging tabs
located at the back of the Audio Alarm.
2. Turn them around and slide them back into
place so that the two tabs are pointing up
and the two keyholes are visible from the
front.
INSTALLING THE DOOR/WINDOW SENSOR (WT-433)
It is recommended to install one sensor on your front door and the other on
your back door.
Each contact sensor has 4 parts:
Transmitter Magnetic Switch Magnet Spacers