Sharp Aquos LC 45GD4U - Manual (Page 59)

58
Using external equipment
Setting the recording mode (i.LINK)
• The function for automatically adjusting the recording
mode of connected D-VHS decks can be turned on
or off.
• Since most of the currently available D-VHS decks
automatically recognize the transfer rates of the
pictures and sound being recorded and control the
recording mode accordingly, you should always set
this Mode to “Pass thru” in normal circumstances.
• Depending on the D-VHS deck used and the type of
broadcast being recorded, this TV may not adjust
the recording mode properly. In this case, please
set the “Recording Mode” to “Pass thru”.
Press MENU and the MENU screen displays.
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and then
press ENTER.
1
2
3
Press a/b to select “Recording Mode”, and
then press ENTER.
4
Press c/d to select “Auto” or “Pass thru”,
and then press ENTER.
• Normally, this should be set to “Pass thru”.
5
Setting the Standby Mode (i.LINK)
• Power consumption during standby mode can be
minimized by changing the setting of the “Standby
Mode” in “i.LINK Setup”.
• When i.LINK is not in use, select “Inactive” in
“Standby Mode”.
Press MENU and the MENU screen displays.
Press c/d to select “Digital Setup”.
Press a/b to select “i.LINK Setup”, and then
press ENTER.
1
2
3
Press a/b to select “Standby Mode”, and
then press ENTER.
4
Press c/d to select “Active” or “Inactive”,
and then press ENTER.
5
“Active”: Power continues to pass through the i.LINK
circuit so data can be relayed.
“Inactive”: Power consumption is minimized during
standby mode. Data cannot be relayed at this
setting.
NOTE
• When the main power of the TV is in standby mode
(POWER indicator lights off), i.LINK control commands
cannot be received from a D-VHS deck. This does not
change even if the “Standby Mode” is set to “Active”. To
control the TV from a D-VHS deck, turn the TV power on
(POWER indicator lights up in blue).
• Data cannot be relayed between i.LINK devices when all
the following conditions are met: 1) More than one i.LINK
device is connected to the TV with i.LINK cables, 2)
“Standby Mode” is set to “Inactive”, and 3) The power of
the TV is in standby mode (POWER indicator lights off).
When the TV is connected between two i.LINK devices in
series, select “Active” in “Standby Mode” or connect the
TV at an end of the series as shown in the diagram.