Sharp UX-465L - Manual (Page 26)

Setting the Reception Mode
24
Setting the Reception Mode
Your fax has three modes for receiving incoming calls and faxes:
RECEPTION MODE key
TEL mode:
Select this mode when you want to
receive both phone calls and faxes on
the line connected to the fax machine.
All calls, including faxes, must be
answered by picking up the fax
machine's handset or an extension
phone connected to the same line.
FAX mode:
Select this mode when you only want
to receive faxes on your line. The fax
machine will automatically answer all
calls on four rings and receive
incoming faxes.
TAD mode:
Select this mode when you are out
and want the built-in answerig
machine to answer all calls. Voice
messages will be recorded, and fax
messages will be receive
automatically ("TAD" is an acronym
for "Telephone Answering Device".)
2 1 3
9
4 5 6
7 8
0
open
LCR
FAX TEL
TAD
FAX TEL
TAD
FAX TEL
TAD
FEB 1 10:30
FEB 1 10:30
FEB 1 10:30
RECEPTION
MODE
Setting the reception mode
Press the RECEPTION MODE key
until the arrow in the display points to
the desired mode.
Note: TAD mode cannot be selected
unless a general outgoing message
has been record as explained in
Chapter 3 (see page 37).
For more information on receiving
faxes in TEL and FAX modes, see
Chapter 5,
Receiving Documents
(page 71). For more information on
using TAD mode, see Chapter 3,
Using the Answering Machine (page
37).