SMSC SMC6516TF - Manual (Page 76)

5-18
C
ONFIGURING AND
M
ONITORING
Port [x] Configuration Menu
The Port [x] Configuration Menu is accessed from the Port
Summary Configuration Menu by entering the number of a port
whose settings are to be edited.
___________________________________________________ >>>>
Port [x] Configuration Menu <<<<
1. Port Status.............................. [ Enabled ]
2. Port Path Cost........................... [ 100 ]
3. Port Priority............................ [ 128 ]
4. Port Duplex Mode......................... [ Auto ]
5. Auto-Negotiation Mode ................... [ On ]
6. Port Speed .............................. [ Auto ]
<ESC> To Exit Menu
Enter Selection:
___________________________________________________
Figure 5-12. Port [x] Configuration Menu
Menu Selections*
Port Status—Allows you to enable or disable the port. When a
port is disabled, it is not included in the Spanning Tree
Algorithm.
Port Path Cost—Allows you to enter the port path cost
(1 - 65535), a Spanning Tree Protocol parameter. The default
value is 100.
Port Priority—Allows you to enter the priority (0 - 255) of the
port relative to other ports The default value is 128.
Port Duplex Mode—Allows you to select either half- or full-
duplex operation. If Auto-Negotiation is enabled, this menu
item is automatically set.
Auto-Negotiation Mode—Allows you to turn Auto-Negotiation
for the 100BASE-TX ports on and off.
Port Speed—Allows you to select the line speed for the
100BASE-TX ports. If Auto-Negotiation is enabled, this menu
item is automatically set.
* Note: Menu selections 1-4 apply to all ports. Selections 5 and 6 only apply
to 100BASE-TX ports.