Starter diagnostics – ScyTek Electronics 1000RS User Manual

Page 17

Advertising
background image

Astra 1000RS - Page 13

independent left and right parking light circuits, diodes must be installed to keep the circuits

separate. NOTE: Do not connect the WHITE wire to the vehicle’s headlight circuit.

Pin 16 RED WIRE: Module Power Input (+). Connect to a constant source of +12V.

2-Pin Blue Connector: Valet switch port. Mount switch where it is accessible from the driver’s

position.
2-Pin Red Connector: LED port. Mount LED where it may be easily seen from either side of the

vehicle.
3-Pin White Door Lock Connector: Door lock port.

· BLUE WIRE - negative unlock output (-) 500mA.

· RED WIRE - (+) 100mA trigger output for optional plug-in door lock relay module,

· GREEN WIRE - negative lock output (-) 500mA.

5-Pin White Flat Connector: Antenna connector port.

Starter doesn’t start and Side Lights flash:

3 Times - Hood Trigger is active
4 Times - Brake Lights stay On
5 Times - Unit is in Valet (service) mode, and start is disabled.
6 Times - Handbrake Off (manual transmission Mode Only).
7 Times - Start sequence not initiated (manual transmission Mode Only).

Starter Diagnostics

Advertising