ScyTek Electronics 1000RS - Manual (Page 6)

Remote Transmitter Description
The Astra 1000RS is supplied with one 5-button Remote Transmitter used to control system operations.
Button 1 Locks the doors and when held for 2 seconds, activates the system’s Car locator feature.
Button 2 Unlocks the doors.
Button 3 Activates the Auxiliary 1 output. Type of output can be programmed for customization.
Button 4 Activates the Remote Start feature.
Button 5 is the Page Shift button. Each time the Shift Button is pressed, the LED on the transmitter will
illuminate and the transmitter functions will shift to the next page, allowing access to another set of
features. Once shifted to another page (there are 4 pages total), the transmitter will remain on that page
for 10 seconds or until a button is pressed, then return to page 1. Each time a transmitter button is pressed
and held, the LED will flash a number of times to indicate from which page it is transmitting. Under normal
operation, only pages 1 and 3 are used. Page 1 is the default page and operates lock, unlock, aux and
remote start. Page 3 (press side button 2X) is used for Two Car Operation (see page 3). Other pages and
channels may be used in the future.
Adding/Replacing Transmitters
To replace lost or stolen transmitters or to add additional transmitters into the system, have all desired
transmitters ready and follow the steps below.
Note: Up to four 1-way transmitters or two 2-way transmitters can be programmed to operate the system.
To erase any previously stored transmitter codes, be sure to program all 4 transmitter memory locations.
To program 1-way transmitter(s):
1. Turn the ignition key On, Off, On, Off, and back On.
· The parking lights will flash 3 times.
2. Press and hold the Override switch for 5 seconds.
· The parking lights will flash 5 times.
· The LED will illuminate.
Page 2 - Astra 1000RS
Remote Transmitters
Button 1 Button 2
Button 5
LED
Button 3 Button 4