Sunrise Medical QUICKIE G-424 - Manual (Page 14)

930484 Rev. A 27
I X . S E T - U P , A D J U S T M E N T & U S E
TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you will need the following tools:
• 7/16" box and open-end wrench
• 1/2" box and open-end wrench
• 3/4" box and open-end wrench
• 3/4" socket wrench
• 5/32" Allen wrench
• 3/16" Allen wrench
• Phillips screwdriver #2
• Custom axle wrench (or a 1/2" open-end wrench)
You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you
need from a hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself, Sunrise recommends that you
use a torque wrench.
Note: The wrench must measure inch-pounds.
You can buy a torque wrench and proper sockets
from a hardware store.
CHECK-OUT
Be sure this chair performs to your chosen operational settings. If it does not,
turn the chair off immediately and reprogram with the Quickie QTRONIX
Programmer. If you do not own a Quickie QTRONIX Programmer have your
SUPPLIER reprogram your wheelchair as needed. Or, you can order a
Quickie QTRONIX Pad for your own use, from your supplier.
Note: Repeat this procedure until the chair performs to your specifications.
When properly set up, this chair will operate smoothly. Check to see that all components
work properly. If you detect a problem, be sure to correct it before use.
26 930484 Rev. A
NOTES:
1. Work Surface For Set-Up:
Use a flat surface, such as a table, to assemble, adjust and check your chair.
This makes the steps easier and helps ensure a correct set-up.
2. Fasteners:
• Many of the screws and bolts on this chair are special high-strength fasteners
and may have special coatings.
• Many nuts are of the Nylock type. They have a plastic insert to help
prevent loosening.
• Only use screws, bolts and nuts provided by Sunrise.
1. Use of improper fasteners may cause the chair to fail.
2. Over- or under-tightened fasteners may fail or cause damage to
chair parts.
3. If bolts or screws become loose, tighten them as soon as you can.
Loose bolts or screws can cause damage to other chair parts causing
them to fail.
3. Washers & Spacers:
• Note the position of washers and spacers before disassembly.
• To avoid damage to the frame, replace all washers and spacers when you
reassemble parts.
4. Torque Settings:
• A torque setting is the optimal tightening for a particular fastener. Use a
torque wrench that measures inch-pounds to secure screws, nuts and bolts
on this chair.
Note: Unless otherwise noted, use a torque setting of 120 inch-pounds for all fasteners.
I X . S E T - U P , A D J U S T M E N T & U S E