Sunrise Medical QUICKIE G-424 - Manual (Page 16)

930484 Rev. A 31
I X . S E T - U P , A D J U S T M E N T & U S E
I. FLIP BACK WIDTH ADJUSTABLE
ARMRESTS (CONTOUR & HIGH
BACK CONTOUR SEAT)
1. Installation/Removal or Adjustment
a) Insert armrest support (A) inside of 1"
square tube (B) located on back of the seat.
b) Repeat for other side of seat.
c) Position armrest at appropriate width.
d) Tighten set screws (C) on square tube
using allen wrench.
J. ANGLE ADJUSTMENT
ARMRESTS
1. Adjustment
a) Flip back armrest.
b) Adjust the angle of the armrest by
turning the bolt (D) clockwise to
reduce the angle and counter
clockwise to increase the angle.
c) Fully tighten the jam nut.
K. DUAL-POST HEIGHT-ADJUSTABLE
FLIP-BACK ARMRESTS
(SEAT FRAME ONLY)
The dual-post flip-back armrest can be
used as either a flip-back armrest or a
removable armrest.
1. Installing Armrest
a) Flip levers A and B to open receivers.
b) Insert front and rear armrest posts
into receivers.
c) Flip levers A and B to engage.
2. Set-up for Flip-back Operation
a) Flip lever A so front post is able to lift
free.
b) Armrest now has the ability to be
flipped back without removal.
3. Set-up for Removal
a) Flip levers A and B so front and rear
posts are able to lift out freely.
b) Armrest can now be easily removed
for transferring.
4. Height-Adjustment
a) Release the upper securing lever (C).
b) Set at desired height
c) Return securing lever to locked position.
d) Move armrest up or down to allow
armrest to snap into place.
A
B
C
C
A
B
30 930484 Rev. A
I X . S E T - U P , A D J U S T M E N T & U S E
F. REMOTE JOYSTICK
INSTALLATION
1. To Connect
a) Line up female cylindrical connector
(C) with its male receptacle on the
end of the power cable (D).
b) Push in firmly.
2. To disconnect
Pull back on the retaining ring of the
cylindrical connector (C) until it
disconnects from the power cable (D).
G. TO ADJUST THE HEIGHT OF
THE REMOTE JOYSTICK
a) Remove the two pan-head screws (A),
securing the angle bracket mount (B).
b) Remove the joystick from the mount
by unfastening the two screws (C) on
the underside of the mount.
c) Position angle bracket mount such that
you achieve the desired joystick height.
Four positions are available by
relocating the mount either on the top
or bottom of the mounting bar (D)
and/or by rotation of the angle
bracket mount.
H. REMOTE JOYSTICK
SWING-AWAY RETRACTABLE
MOUNT (OPTIONAL)
The joystick is mounted with a
mechanism which allows the control to
be locked in a forward or retracted
position.
1. Adjustment
a) To retract joystick, press firmly on
inside of joystick (E).
b) Push joystick away from front of armrest
until it locks into retracted position.
c) To return to forward position, pull to
release magnetic catch and swing.
d) Tension adjustment can be made by
tightening through bolt (F).
E
F
A
C
C
D
D
B
D