Sunrise Medical QUICKIE G-424 User Manual
Page 19
930484 Rev. A
37
X .
O P E R A T I N G G U I D E
c. Turn on power to the chair; program as needed.
d. Remove plug and cycle ON/OFF switch to drive chair.
Note: Review the Quickie QTRONIX Programmer Owner’s Manual for more
details on how to program your chair.
Note: Program settings that are not matched for the capabilities of the rider
can result in serious injury. Do not alter settings without the advice of your
health care professional.
C. THERMAL ROLL-BACK
Your chair has a thermal roll back circuit.This protects the controller from
damage due to overheating. In extreme conditions (such as repetitive hill
climbing) the circuit will decrease the power to your motors.This allows the
chair to operate at a reduced speed.When the controller cools, the chair will
return to normal speed.
D. CIRCUIT BREAKERS
1. Notes:
Your Quickie G-424 has a circuit breaker
protruding through the shroud cover at
the right rear of the chair.
•
In the unlikely event of a short circuit
or heavy overload, all power to your
chair will be shut off.
•
To reset your chair, depress the circuit
breaker button located at the rear
corner of the chair. A few minutes
wait is required before the circuit
breaker will reset.
2. Repeated Shutdown:
If the chair continues to shut down
after resetting, have it serviced by
a supplier.
E. INTEGRAL JOYSTICK
The standard integral joystick controls the
chair’s performance. It consists of the
following parts:
1. Speed Control or Drive Mode
Selection Buttons (A and B)
To decrease the speed level depress button
A. Or, when 1- 5 Drive modes are
programmed, depress button A to activate
lower drive mode(s).
Circuit
Breaker
36
930484 Rev. A
X .
O P E R A T I N G G U I D E
A. PERFORMANCE CONTROL SETTINGS
1. It is vital to match control settings to your level of function and ability.
2. Consult your health care professional and your supplier to select the best
control settings for you.
3. Check and adjust the settings every six to twelve months (or more often, if needed).
4. Adjust the control settings immediately if you notice any change in
your ability to:
•
Control the joystick.
•
Hold your torso erect.
•
Avoid running into objects.
5. Control Settings are adjusted through the use of the Quickie QTRONIX
Programming Pad. See your supplier if you do not own a Quickie QTRONIX
Programming Pad.
B. QUICKIE QTRONIX PROGRAMMER PAD (OPTIONAL)
Program settings beyond the ability of the rider can result in serious injury. Consult
your health care advisor before you alter settings.
1. Notes:
The Quickie QTRONIX Programmer lets
you adjust the performance control
settings of the G-424. You can
customize a program for yourself or
select the standard program.
•
acceleration rate
•
deceleration rate
•
turn acceleration
•
turn deceleration
•
forward speed (max & min)
•
reverse speed (max & min)
•
turn speed (max & min)
•
steer correct
Remote systems
•
4-axis joystick throw
•
sleep timer
•
profile number
•
read timer
2. To Program Your Chair:
a. Turn off power to the chair.
b. Insert Quickie QTRONIX Programmer
plug (A) into the programmer/charger
socket on the front of the joystick.
A
A
D
F
G
H
B
E
C
Integral Joystick