Sunrise Medical QUICKIE G-424 - Manual (Page 25)

930484 Rev. A 49
X I I I . W I R I N G D I A G R A M S
Wiring Diagram Detail (Remote System)
48 930484 Rev. A
X I I . M A I N T E N A N C E
Note: Do not use pneumatic inner tube in tires with two-piece rims.
i. Reassemble the wheel.
Use a torque setting of 420 in.-lbs. to re-tighten bolts.
j. Install wheel on chair by replacing center lock washer, nut and
plastic dome. Use a torque setting of 180 in.-lbs. to retighten bolts.
k. Inflate tire to proper pressure level (listed on tire sidewall).
G. MOTOR BRUSHES
Check the motor brushes every four (4) months for wear.The brushes should
be clean and shiny. Replace worn or blackened brushes.
H. ORDERING PARTS
When you order parts, provide the following:
1. Model of chair
2. Serial number of chair
3. Left hand or right hand control
4. Part number, description and quantity of parts you need.
5. State reason for replacement.
I. MAINTENANCE CHART
You should check the items on this chart at the indicated intervals. If any of
the items are loose, worn, bent or distorted, immediately have them checked
and/or repaired by your authorized Sunrise supplier. Frequent maintenance and
servicing will improve performance and extend wheelchair life, and help
prevent injuries.
Charge Batteries
Check tires for proper inflation level
Check batteries for proper electrolyte level (wet cell only)
Check plugs and connectors for proper connections
Check all moving parts for wear
Inspect all nuts, bolts and fasteners for looseness or wear
Inspect upholstery for wear
Remove and inspect motor brushes
Servicing by authorized Supplier
CHECK...
✓
✓
✓
✓
✓
✓
✓
✓
✓
Quar
terly
Annually Monthly W
eekly Daily