Motorola TimePort 280 - Manual (Page 143)

143
Adjusting Your Settings
Enter a note as follows:
6CUM #EVKQP
Change the
octave Set the new octave (  ,  , or  ) before
selecting the note. The new octave applies
to the note and all following notes until
you change it again.
Select the note
(required) Press a keypad key to enter a note.
Change a note to
a sharp or flat Enter a sharp or flat ( or E ) after
selecting the note.
Some sharps and flats are played as
standard notes. For example,
% is the
same as & . Press
S
to scroll to valid
notes when entering a new note.
Change a note’s
length Set the new length ( K , Z , or T ) after
selecting the note. The new length applies
to the note and all following notes until
you change it again.
Add a rest Enter one or more rests ( 5 characters) as
needed in the tone sequence. You can set
the length of the rest by entering an
K , Z
or T character after the rest, just as you
can for a note.
Listen to a new
tone as you
compose it Press M to enter the &RPSRVH 0HQX ,
and select 3OD\ $OO to play the notes you
have entered.
User.Guide.GSM.book Page 143 Wednesday, July 11, 2001 5:07 PM