Sony CDP-CX260 - Manual (Page 39)

39
Additional Information
Specifications
Compact disc player
Laser Semiconductor laser ( λ = 780 nm)
Emission duration: continuous
Laser output Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 20 Hz to 20 kHz ±0.5 dB
Signal-to-noise ratio More than 108 dB
Dynamic range More than 98 dB
Harmonic distortion Less than 0.0045 %
Channel separation More than 100 dB
Outputs
LINE OUT
DIGITAL OUT
(OPTICAL)
General
Power requirements
Where purchased␣
USA
UK
Power consumption 13 W
Dimensions (approx.) When the front cover is closed
(w/h/d) 430
Ч
200
Ч
480 mm (17
Ч
7 7/8
Ч
19 in.)
incl. projecting parts
Mass (approx.) 9.5 kg (21 lbs)
Supplied accessories
• Audio cord (1)
• CD booklet holders (2) and label (1)
• DC-cable (1)
• Monaural (2P) mini-plug cord (1)
• Remote commander (remote) (1)
• Sony LR6 batteries (3)
• Transmitter/receiver (1)
Design and specifications are subject to change without notice.
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There is no sound.
/ Check that the player is connected securely.
/ Make sure you operate the amplifier correctly.
The CD does not play.
/ There is no CD in a slot (“–NO DISC–”
appears).
Insert a CD.
/ Insert the CD with the label side facing right.
/ Clean the CD (see page 38).
/ Moisture has condensed inside the player. Open
the front cover and leave the player turned on
for about an hour (see page 38).
The remote does not function.
/ Remove obstacles in the path of the remote and
the player.
/ Point the remote at the remote sensor g on the
player.
/ Be sure to connect the player and the
transmitter/receiver correctly.
/ Be sure to set up the remote correctly.
/ Turn both the player and the transmitter/
receiver on.
/ Point the remote at the remote sensor g on the
player and the transmitter/receiver.
/ Replace all the batteries in the remote with new
ones if i appears in the remote’s display.
The player functions incorrectly.
/ The microcomputer chips may be operating
incorrectly. Disconnect the AC power cord, then
connect it back to the wall outlet to reset the
player.
Load impedance
Over 10 kilohms
Wave length: 660 nm
Maximum
output
level
2 V
(at 50 kilohms)
–18 dBm
Jack
type
Phono
jacks
Optical
output
connector
Power requirements
120 V AC, 60 Hz
220 V – 230 V AC, 50/60 Hz