Sony CDP-CX260 - Manual (Page 5)

Playing CDs Getting Started
5
Getting Started
Hooking Up the System
Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
What cords will I need?
Audio cord (1) (supplied)
White
(L)
Red
(R)
White
(L)
Red
(R)
Hookups
When connecting the audio cord, be sure to match the
color-coded cords to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
Amplifier
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
CD player
DIGITAL OUT
(OPTICAL)
COMMAND MODE
To S-LINK/CONTROL A1
jack
Amplifier
To line output (L) To line output (R)
To an AC outlet
: Signal flow
To audio input
POC-15
Optical cable (not supplied)
CD player Digital component
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software
other than music, such as a CD-ROM.
To an AC outlet
LINE 2ND CD
IN OUT
L
R
L
R
INPUT
CD
L
R
DIGITAL OUT
OPTICAL
DIGITAL INPUT
OPTICAL
• To connect the transmitter/receiver
Connect the transmitter/receiver via the TO TMR-IA10 jack
using a DC-cable (supplied) and via the S-LINK CONTROL
A1 jack using a monaural (2P) mini-plug cord (supplied).
To DC IN 6V
Transmitter/receiver
To TMR-IA10
To S-LINK/CONTROL A1
jack
DC-cable (1) (supplied)
CD player Transmitter/receiver
DC OUT 6V
( TRANSMITTER RECEIVER )
TO TMR - I A10
S - L I NK
CONTROL A1
DC IN 6V
CONTROL A1