Servis-Rhino RC-12 - Manual (Page 40)

ASSEMBLY
RC12 12-05 Assembly Section 3-4
© 2005 Alamo Group Inc.
ASSEMBL
Y
• Place key (item 1) in end of jackshaft and slide round end of PTO shaft over jackshaft. Attach with two 3/8"
set screws (item 2). Align set screws with dimples in jack shaft. Apply thread locking compound to threads
to prevent loosening. Ensure driveline and jackshaft U-joint are in phase. Asm-FL-0066.
• Place jack shaft shield (item 1) in place over shield mount (item 2) and bearing stand. Fasten in place with
two 3/8" bolts, lockwashers and washers at shield mount and on either side of bearing mount. Asm-FL-
0067.