Servis-Rhino RC-12 - Manual (Page 41)

ASSEMBLY
RC12 12-05 Assembly Section 3-5
© 2005 Alamo Group Inc.
ASSEMBL
Y
3-POINT HITCH ASSEMBLY INSTALLATION
(Lift Models Only)
• Raise hitch into position with hoist. Place narrow section of lower hitch between mounting plates on front of
mower. Fasten with 1-7/16" pins (item 1) to lower holes and lock with snapper pin (item 2). Asm-FL-0068.
• Attach clevis portion of link bar assembly (item 3) to mounting point on top front of center plate. Attach
spacer (item 5) to end of pin (item 4) and fasten with 1/2" bolt (item 6) and lockwasher. Asm-FL-0068.
• Raise hitch with hoist and insert pin (item 7) through slotted end of link bar and top rear hole on hitch
assembly. Fasten with snapper pin (item 2). Asm-FL-0068.
• Slide PTO shaft on to gearbox input shaft and align hole in yoke with hole on shaft. Shaft will only attach at
one position. It may be necessary to rotate yoke 180°. Fasten with 5/16” bolt and nut. Asm-FL-0069.
• Bolt gearbox shield in place with four 5/8” cap screws, flatwashers, and lockwashers. Asm-FL-0069.