Sirius Satellite Radio PowerConnect XMP3IVKUG0210 - Manual (Page 32)

32
Vehicle Installation
• Sedan/Coupe with the Antenna Placed at the Front of the Roof:
1 . Feed the antenna cable from the antenna underneath the rubber
molding around the windshield . Use a blunt plastic putty knife or
similar blunt tool to lift the rubber molding around the windshield
and tuck the antenna cable underneath the molding . Route the
antenna cable around and down the windshield to the lowest point .
2 . At the lowest corner of the windshield, route the cable out of the
windshield molding and into the rubber weather stripping around
the door opening . Lift
the weather stripping
from the opening and
tuck the cable inside it,
then replace the weather
stripping . Run the cable
inside of the weather
stripping to the bottom of
the door opening .
3 . Pull the cable out of the
weather stripping at the bottom of the door opening and route it
under the carpet toward the dashboard . Coil any excess cable in a
hidden location, such as under the carpet, keeping it away from any
vehicle pedals or controls . Secure the excess cable with wire ties .
4 . Bring the end of the cable out at the PowerConnect Vehicle Dock
location . Leave yourself enough cable so you can easily connect it
to the antenna connector of the dock .
5 . Continue with “Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter” on page 37 .