SmartBridges sB3410 - Manual (Page 27)

Page 27 of 66
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airClient™ Nexus User Guide
10. Enter the values of Ethernet Port Priority and/or Port Path Cost for ETHA.
11. Enter the values of Ethernet Port Priority and/or Port Path Cost for ETHB.
12. Enter the values of Ethernet Port Priority and/or Port Path Cost for Radio A
13. Click on ’Apply Changes’ Button to save to the current configuration file.
Figure 2-13 Bridge Configuration
2.8. airClient Router/NAT Configuration
The airClient unit can also be configured in Router or NAT mode which behaves like Infrastructure mode.
The procedures for configuring the parameters in Router mode are given below. In this mode, the units
will associate with any access point.
Note: The configuration procedure of parameters in NAT mode is the same as for Router mode.
2.8.1. Ethernet Configuration
The Ethernet IP is configured during the operational mode change to airClient Router mode.
Follow these steps below if you need to re-configure the airClient Router Ethernet parameters: