Sony RS-232C - Manual (Page 53)

– 53 –
• Video signal type (17th through 22nd byte)
This command is used to set the type of video signal of the equipment connected to LINE4 A to F.
• Projector protocol (23rd byte)
This command is used to select protocol of the projector to be connected.
Bit 0 of the “PJ CONTROL” changes depending on the protocol.
Example: When setting the respective parameters as shown below.
LINE3 machine type : CD
LINE3 connected channel : 1
LINE4A-F machine type : NONE
LINE4A-F machine type : 2
CONTROL S I/F TYPE : CH1 is set to IR, and CH2-4 are set to WIRED.
PJ CONTROL : REMOTE POWER ENABLE is set to ON.
LINE4 A-C signal define : VIDEO
LINE4 D-F signal define : RGB
Projector protocol : VPL-FX50
43[H] 4D[H] 54[H] 53[H] 37[H] 40[H] 30[H] 41[H] 30[H] 41[H] 30[H] 41[H] 30[H] 41[H] 30[H]
41[H] 30[H] 41[H] 41[H] 42[H] 30[H] 30[H] 30[H] 32[H] 32[H] 32[H] 30[H] 30[H] 0D[H]
(‘C S I O 7 @ 0 A 0 A 0 A 0 A 0 A 0 A A B 0 0 0 2 2 2 0 0 CR’)
REMOTE PARAMETER REQUEST : 52[H] 50[H] 49[H] 4F[H] (‘RPIO’)
This command is used to read setups of the CONTROL S OUTPUT and PROJECTOR CONTROL from the SRP-X700P.
• Packet format
52[H] 50[H] 49[H] 4F[H] 0D[H]
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] (‘A’)) in the
order shown below.
41[H] “parameter” 0D[H]
The parameter is the same as the 24 byte parameter of the REMOTE command.
SIGNAL DEFINE
VIDEO 30[H] (‘0’)
S VIDEO 31[H] (‘1’)
RGB 32[H] (‘2’)
COMPONENT 33[H] (‘3’)
LAN 34[H] (‘4’)
VPL-FX50 30[H] (‘0’) 0 1.00 and higher
VPL-PX32/31/21 31[H] (‘1’) 0 1.00 and higher
PFM-42B1 32[H] (‘2’) 0 1.00 and higher
VPL-PX15 33[H] (‘3’) 1 1.00 and higher
VPL-PX10/PS10 34[H] (‘4’) 1 1.00 and higher
VPL-CX11/CX10 35[H] (‘5’) 1 1.00 and higher
SANYO LP-XP45/40 36[H] (‘6’) 0 1.00 and higher
VPL-PX11 37[H] (‘7’) 0 1.20 and higher
VPL-PX40/35 38[H] (‘8’) 0 1.20 and higher
PFM-50C1 39[H] (‘9’) 0 1.20 and higher
User define 7A[H] (‘z’) 0 1.10 and higher
Supported firmware
version PJ CONTROL
bit0
PROTOCOL