Sony RS-232C - Manual (Page 62)

– 62 –
ATT LEVEL ATT LEVEL ATT LEVEL
30[H] (‘0‘) 18 42[H] (‘B ’) 8 4C[H] (‘L ’)
30 39[H] (‘9‘) 17 43[H] (‘C ’) 7 4D[H] (‘M ’)
27 3A[H] (‘:‘) 16 44[H] (‘D ’) 6 4E[H] (‘N ’)
25 3B[H] (‘;‘) 15 45[H] (‘E ’) 5 4F[H] (‘O ’)
24 3C[H] (‘<‘) 14 46[H] (‘F ’) 4 51[H] (‘Q ’)
23 3D[H] (‘=‘) 13 47[H] (‘G ’) 3 53[H] (‘S ’)
22 3E[H] (‘>‘) 12 48[H] (‘H ’) 2 55[H] (‘U ’)
21 3F[H] (‘?‘) 11 49[H] (‘I ’) 1 57[H] (‘W ’)
20 40[H] (‘@‘) 10 4A[H] (‘J ’) 0 59[H] (‘Y ’)
19 41[H] (‘A‘) 9 4B[H] (‘K ’)
∞
• ATT (12, 22nd byte)
This command is used to set the ATT level [dB] of SPEAKER OUTPUT.
SPEAKER OUTPUT PARAMETER REQUEST : 52[H] 4F[H] 53[H] 50[H] (‘ROSP’)
This command is used to read the setup of the SPEAKER OUTPUT from the SRP-X700P.
• Packet format
52[H] 4F[H] 53[H] 50[H] “parameter” 0D[H]
• Parameter
Specify the scene No. of the scene memory that you want to read, as the parameter.
Method of specifying the scene No. is the same as that of the GROUP FADER command. See page 29.
• Return packet format
When communication with the SRP-X700P is established with success, the parameter is returned together with ACK (41[H] (‘A’)) in the
order shown below.
41[H] “parameter” 0D[H]
The parameter is the same as the 21 bytes of the SPEAKER OUTPUT command parameter from which the scene No. is exempted.
Sony Corporation Printed in Japan 9-870-518-12